Describe both bands and the moving mechanism

A component record should reproduce the complete geometry without turning catalogue webbing data into a finished-collar safety claim.

Main band
What to record: Part code, width, thickness, face direction and adjusted length range
Project detail: ____________________
How to confirm: Measure the finished band between defined references

Moving loop
What to record: Separate part code, cut length, finished loop length and threading direction
Project detail: ____________________
How to confirm: Lay against its controlled drawing before assembly

Rings and sliders
What to record: Part identities, internal geometry, finish and orientation
Project detail: ____________________
How to confirm: Match actual hardware to drawing and sample record

Folds and seams
What to record: Fold direction, layer stack, overlap, seam location and bulk
Project detail: ____________________
How to confirm: Approve a section view and finished end samples

Travel and stops
What to record: Relaxed position, buyer-defined limiting position and stop locations
Project detail: ____________________
How to confirm: Move a marked assembly on the agreed fixture

Buyer validation
What to record: Intended product range, inspection method and final acceptance owner
Project detail: ____________________
How to confirm: Link results to the buyer's controlled validation plan

The buyer defines fit, use and acceptance for the finished collar; component information alone does not establish product safety.

Sinicwebbing — https://www.sinicwebbing.com